Rotho Babydesign Kiddy Wash mint children's washbasin 12m+

-Rotho Babydesign Kiddy Wash -children’s washbasin for the bathtub -for children aged 12 months and older, with adult supervision -attaches to the edge of a bathtub up to 8 cm wide -drain with plug -mirror with reflective film -ex-display condition, very good; packaging may be damaged or replaced The mint-green Kiddy Wash washbasin by Rotho Babydesign helps make handwashing and toothbrushing accessible for young children. It attaches to the edge of a bathtub up to 8 cm wide, with the supports positioned as instructed. The mirror can be adjusted to different positions, and the handle on the side can be used to hang a towel. The plug closes the drain, allowing water to flow into the bathtub. The manufacturer specifies use from 12 months of age. An adult must supervise the child at all times and check the water temperature. Care and safety Before hanging the washbasin on the edge of a bathtub up to 8 cm wide, attach the brackets to the underside, slide them into the guides, and adjust them to fit the bathtub edge. The washbasin should be supported and tilted slightly inward over the bathtub. Snap the mirror frame into the side openings on the back edge; its position can be adjusted. Place the cup in the recess at the back, and close the drain with the plug before filling with water. The recess at the front is for soap, and the handle on the right is for hanging a towel. Wash the cup with warm water before first use. Check the water temperature: maximum 37°C. When not in use, store out of children’s reach. Clean the product with a soft cloth and soapy water. Do not use harsh or abrasive cleaners or abrasive cloths/sponges. When cleaning, check that the connections are secure and that there are no white spots on the plastic. Damaged products must not be used again! An older instruction manual for the same Kiddy Wash also recommends lukewarm water with a neutral-pH cleaner and prohibits solvents and caustic or scratch-causing cleaners. Do not expose the product to extreme temperatures or severe temperature fluctuations, including frost or temperatures above 60°C/140°F. Keep the original packaging for transport, storage, and any potential complaints. Sort and dispose of the packaging and product in accordance with applicable regulations through an authorized provider or municipal facility. Before first use, it is worth checking the manufacturer’s recommendations, age requirements, compatibility, and cleaning instructions for this model. For children’s products, regularly check all components and stop using the product if it is damaged or excessively worn. If the product is compatible with other accessories, it is worth checking the dimensions, model compatibility, and required mounting components before purchasing or using it. IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. When passing the product on to others, include these instructions for use. The instructions for use are part of the product. WARNING – THIS IS NOT A TOY! IT IS A CARE PRODUCT! Complies with applicable safety regulations. WARNING - NEVER LEAVE A CHILD UNATTENDED! • Never leave a child unattended during bathing, even for a moment. If you have to leave the room, take the child with you. • Do not let another child, even an older one, take the place of an adult. • Before use, check that the product is positioned correctly and securely! • Do not use if the product is damaged, or if any part is missing or loose - risk of injury! • Use only original Rotho Babydesign parts. • The product must not be used or operated by people with limited physical, sensory, or cognitive abilities or without the appropriate knowledge! • The mirror is covered with shatter-resistant reflective film. • The mirror is unbreakable because it is covered with reflective film. Caution! Before use, an adult should remove and discard the plastic packaging and the protective film on the mirror. - Choking hazard! Caution! The safety instructions on the side of the product must be followed without fail! - Risk of injury! Caution! There is a risk of drowning even in shallow water (±2 cm/±1 inch)! Caution! Check the water temperature (max. 37°C/99°F) - Risk of scalding! Note: Follow the assembly instructions! Note: The product is designed to be attached to a bathtub and must not be used in any other way! Note: Wash the toothbrushing cup thoroughly with warm water before first use. Note: Use only original Rotho Babydesign replacement parts. FAQ Which bathtub does the washbasin fit? The instructions specify attachment to the edge of a bathtub up to 8 cm wide, with the supports correctly positioned. How do I care for the washbasin? Clean with a soft cloth and soapy water. Check the connections and plastic for damage, including white discoloration. Specifications Shipping time: 24 hours Safety documents Rotho Babydesign Kiddy Wash manufacturer’s instructions: https://redirects.rotho.com/ava-waschbecken